How to install frosted glass in the bathroom?
Frosted glass, is also known as frosted glass and dark glass. It is made of ordinary flat glass by mechanical sandblasting, manual grinding, or hydrofluoric acid dissolution to make the surface uniform. Because the surface is rough, the light is diffusely reflected, and the light is transparent but not transparent. It can make the indoor light soft and not dazzling. It is often used in doors, windows, and partitions of bathrooms, toilets, and offices that need to be hidden. When using it, the frosted side should face the window.
The frosted glass door of the bathroom can face the inside or outside of the bathroom, but it is recommended to use double-layer frosted glass.
In general, it is easy to use frosted glass for the bathroom or kitchen door during family decoration. When the frosted side faces inward, the frosted glass will become transparent due to water and oil. When the frosted side faces outward, the glass will become transparent when it is wet outside. It is also very simple to solve this problem. With double-layer frosted glass, the frosted side faces inward. Whether from the inside or the outside, you can see the glossy surface of the frosted glass, which also increases the beauty of the visual effect. In addition, the rough surface of frosted glass should not be stained with paint. Once stained with paint, it is difficult to clean. So what are the installation methods for frosted glass?
Use double-sided tape to stick to the bottom of the absorption rail, then put the rail in a fixed position, fix it with expansion plugs and nails, and then pop up the vertical line on the wall according to the design scale, and pop up the interval position on the ground and ceiling. Use the main keel to hit the ceiling, vertically with the rail, and then make the lower half on the popped position line according to the requirements of the drawing, and anchor it with the structure at both ends. Insert the main keel connector into the rail and the main keel, and connect them. According to the design requirements, fix the main keel with 4-inch iron nails according to the dividing line position. There should be no less than three nails at each end of the keel, and it must be installed firmly.
Fix the small keel with mortise and tenon or nail according to the dividing line position according to the design requirements, and it must also be installed firmly. Before installing the small keel, you can also open the installation glass groove on the small keel according to the specifications of the installation frosted glass interval. Install frosted glass: install it on the small keel according to the specifications of the frosted glass; if it is installed with a pressure strip, first fix the pressure strip on one side of the glass, and place a rubber pad under the glass, and then fix the glass with the pressure strip; if the glass is fixed directly with glass glue, the glass should be installed in the reserved groove of the small keel first, and then sealed and fixed with glass glue.
